Switching Between Modes
Booster to Harness Mode: Replacing the Harness and Buckle
Pull seat cover forward.
1
Unhook the elastic bands at
2
the back of the seat cover. Pull
the seat cover forward and
over the belly pad.
IMPORTANT: Select the slot
closest to, but not under the child.
Turn and push the buckle
3
retainer through the slot in the
child seat shell.
Pull the belly pad through the
4
corresponding slot in the seat
cover. Place the seat cover
back in its original position
and attach the retaining clips.
Hook the harness straps to the
5
hip anchors.
*
Ensure that the harness is
attached to the top of the
hip anchor.
Insert the harness straps
6
through the slots in the cover
and shell, and over the harness
adjuster plate to the back of the
child seat.
34
Nest the harness straps by
7
inserting the right strap loop
into the left strap loop.
Remove the harness yoke
8
from storage underneath the
seat shell and slide the nested
harness straps completely onto
the harness yoke.
Buckle the harness and pull
9
the adjuster strap to tighten the
harness.
* Pull the harness adjuster away
from the child seat (parallel to
the ground) to tighten.
IMPORTANT: Check all attachments before using the child seat.
Switching Between Modes
35