Booster Mode - Britax PIONEER Guide D'utilisation

Securing Your Child

Booster Mode

WARNING!
• Only use a lap-shoulder belt to secure the child in booster
mode.
• Use the shoulder belt guides on the child seat to ensure
proper fit.
• Ensure the lap part of the vehicle belt sits low across the
child's upper thighs and that the shoulder part does not
contact the child's neck.
Before you begin:
• If your vehicle seat back is adjustable, ensure it is in the
upright position before placing the child seat on the vehicle
seat.
• Adjust the child seat to the upright position and place
forward facing on the vehicle seat, if not already installed
(see page 14).
Adjust the head restraint so
1
the shoulder belt guides
position the vehicle belt in the
closest position at or above
the child's shoulders. The
child's ears should be below
the top of the head restraint.
Pull the vehicle belt out
2
and route the shoulder part
through the shoulder belt
guide.
TIP: Raising the head restraint
to the highest position will
allow for easier access to the
shoulder belt guide.
Fasten the vehicle belt across
3
the child.
* The lap part of the vehicle belt
must be routed low across the
child's upper thighs.
20
Remove slack from the vehicle
4
belt.
* The shoulder part must lie
across the center of the child's
chest, at or above the child's
shoulder.
Checklist
Before traveling, verify that the:
9 Vehicle belt is not twisted.
9 Buckle does not rest on red belt guide.
9 Shoulder part of vehicle belt is routed through the shoulder belt
guide in the closest position at or above the child's shoulder, lies
across the center of the child's chest and does not contact the
child's neck.
9 Lap part of the vehicle belt is routed low across the child's upper
thighs.
Securing Your Child
21