Britax PIONEER Guide D'utilisation page 10

Installing the Child Seat: Harness Mode
Lap Belt
Before you begin:
• Check that your vehicle has a seat belt that can be locked.
* Check your vehicle owner's manual to determine what
type of vehicle belt you have and how it can be locked
for use with child seats.
• Check that your vehicle has a top tether anchor.
* The top tether must be be used at all times when
installing the child seat in harness mode. Using the top
tether will improve the stability of your child seat and
reduce the risk of injury. Check your vehicle owner's
manual for tether anchor locations.
• Loosen the tether and place it over the child seat back to
keep it from becoming pinned between the child seat and
vehicle seat during installation.
• Adjust the child seat to desired position and place forward
facing on the vehicle seat.
14
Installing the Child Seat: Harness Mode
Pull seat cover forward.
1
Pull the vehicle belt out and
2
route along the green belt
path. Verify that the belt is not
twisted and then buckle.
Push the child seat firmly
3
into the vehicle seat while
removing all slack from the
vehicle belt.
* Ensure that the vehicle belt is
locked as directed by your
vehicle owner's manual.
* The child seat is secure when
it cannot be moved front-to-
back or side-to-side more than
2.5 cm (1 in.) at the belt path.
If the child seat is not secure,
repeat the installation procedure
or use a different seating
location.
Firmly press the tether hook
4
over a designated vehicle
tether anchor. Remove slack.
Secure excess webbing with
5
the elastic strap.
Checklist
9 Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 2.5 cm (1 in.) at the belt path. If
the child seat is not secure, repeat the installation procedure
or use a different seating location.
9 Check that any excess tether webbing is contained within
your vehicle and secured in the elastic strap.
2
OR
OR
15