Güde GRP-6501 B&S Traduction Du Mode D'emploi D'origine page 24

6
Procedure
Fig. 4
Fig. 5
Fig. 6
Fig. 7
First, open the petrol cock on the
unit rear side (ON)
To be able to work with the plate
vibrator, put the switch in
(Fig.1/item 2) in position ON .
Set the engine gas lever
(Fig.1/item14) at the starting
function (choke)!
Put the gas lever on the handle
(Fig.1/item15) in the starting
position. . It is possible to start the
plate vibrator with the starting
cable (Fig.1/item13) t.
As the unit starts on, put the
starting lever on the engine
(Fig.1/item14) in working position
run! Put the gas lever on the
handle (Fig.1/item15) in working
position
The unit will start working
immediately after the gas lever on
the handle has been put in working
position .
GB