Leckey Mygo+ Mode D'emploi page 40

p40 Leckey Mygo+ User Manual
SECTION 9.19:
ADJUSTING THE
DYNAMIC BACKREST
To achieve the required amount of
dynamic movement loosen the handle
, slide to the required position and
A
retighten securely. To return the
backrest to a static position, loosen the
handle , slide the backrest strut to
A
the bottom and retighten the handle.
To angle adjust the backrest where a
dynamic backrest has been fitted, you use
the handle at the base of the backrest.
Pull the locking pin
unlock. Lift up the handle
the backrest. Pull the locking pin
Ensure that the locking pin is secure.
The range of the backrest angle and
the range of dynamic movement are
a maximum of 30°, i.e. if the backrest
is upright, a full 30° is available on the
dynamic system. If the backrest angle
is at 10° then only 20° of movement is
available with the dynamic backrest
and so on.
and twist and
B
and adjust
C
.
B
The backrest must be in
the upright position with
the dynamic function
locked off (i.e. the handle
to the lowest position on
C
the backrest supine) and
ensure the locking pin
engaged when the seating
system is used in transport.
A
B
B
is
B
C