Leckey Mygo+ Mode D'emploi page 31

SECTION 9.2:
ADJUSTING THE
UPPER LEG SUPPORTS
The upper leg supports will be set at the
minimum position on arrival. Set the
depth before placing the child in the seat.
Fine adjustment is possible afterwards
but is restricted by the user's weight.
To achieve the correct position measure
the length from the child's lower back
to the back of their knee.
For Size 1 adjust the supports to the
desired position using the locking lever
underneath the seat base. To adjust, press
the locking button and release. Keep the
supports pointing straight forward at this
time unless wind sweeping or adduction,
abduction must be accommodated,
in which case set the angle accordingly
using the locking lever again.
The supports can be readjusted once
the child has been placed in the chair.
A
For Size 2/3, loosen the locking levers
under the seat and slide leg support
to required position. Keep the supports
pointing straight forward at this time
unless wind sweeping or adduction,
abduction must be accommodated,
in which case set the angle accordingly.
Re-tighten bolt. To increase the angle
further, remove bolt and move leg angle
to wider setting. Insert bolt into second
A
slot
B
Single footplate adjusted the same.
A
Leckey Mygo+ User Manual p31
and tighten.
B
B