Technical Characteristics - PRESIDENT Randy III Manuel D'utilisation

1. Unscrew the battery pack door (C). If necessary, remove the belt
clip (C4) or the standard microphone support (C3) to reach the
screw.
2.
Disconnect and remove the old battery pack.
3.
Connect the new battery pack.
4. Screw then battery pack door (C).
Note: The battery pack is provided uncharged, so you must
charge the battery pack before using it with the transceiver.
4) LOW BATTERY FEATURES
When the battery is uncharged the RX/TX LED (16) blinks yellow.
A continuous beep sounds in TX mode.
I) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions
- Weight
- Accessories supplied
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj.
channel
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION
- Maxi. sensitivity at 20 dB sinad
: 40
: AM/FM
: from 26.965 to 27.405 MHz
: 50 ohms
: 13.2 V (mobile configuration)
7.4 V (portable configuration)
inches : 5.98 (H) x 2.62 (W) x 1.46 (D)
mm : 152 (H) x 66.5 (W) x 37 (D)
: 0.67 lb with battery, without
antenna
305 g with battery, without
antenna
: See page 2
: +/- 200 Hz
: 4 W AM / 4 W FM
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 3 KHz
: inferior to 20 µW
: 7 mV
: 1,8 A max.
: 2 %
: AM: 0.5 µV - 113 dBm
FM: 0.3 µV - 116 dBm
23
blinks on the display.