Trouble Shooting; How To Transmit Or Receive A Message - PRESIDENT Randy III Manuel D'utilisation

- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image
rejection rate
- Intermediate frequency
rejection rate
- Drain
- Internal speaker
J) TROUBLE SHOOTING
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR
TRANSMISSION IS OF POOR QUALITY
- Check that the antenna is correctly connected.
- Check that the SWR is properly adjusted (Mobile Configuration
only).
- Check that the programmed configuration is the correct one
(see table page 65).
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEPTION
IS POOR
- Check that the squelch level is properly adjusted.
- Check that the programmed configuration is the correct one
(see table page 65).
- Check that the volume is set to a comfortable listening level.
- Check that the antenna is correctly connected and that the
SWR is properly adjusted (Mobile configuration only).
- You are using the same modulation mode than your correspond-
ent.
3) YOUR CB WILL NOT LIGHT UP
- Check the battery or power supply.
- Check the fuse (Mobile Configuration only).
K) HOW TO TRANSMIT OR RECEIVE A MESSAGE
Now that you have read the manual, make sure that your CB
Radio is ready for use (i.e. check that your antenna is connected).
Choose your channel (19, 27).
: 300 Hz to 3 kHz
: 60 dB
: 1 W
: min: 0.2 µV - 120 dBm
max: 1 mV - 47 dBm
: 60 dB
: 70 dB
: See ECO MODE page 17
: 16 ohms, 1 W
24