Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5) MODE
Use this key to select AM or FM. The modulation mode must correspond with
that of the person with whom you communicate.
A/ Amplitude Modulation (AM) is for communications in areas where there
are obstacles and over medium distances.
B/ Frequency Modulation (FM) is for nearby communications in flat, open
areas. It gives better quality of communication (squelch adjustment needs
more finesse).
6) 6-PIN MICROPHONE PLUG
This plug is situated on the front panel, thereby making it easier to set the
equipment into the dashboard. See the cabling diagram on page 41.
7) UP AND DOWN KEYS
Both keys allow to go up and down the channels by a brief pressure. A con-
tinuous pressure allows to ascend five channels per second.
8) PTT (push to talk)
Depress this knob to transmit a message and release to listen to an incoming
communication.
FREQUENCY BAND SELECTION
(configuration: E; d; EU;EC; U; PL)
The frequency bands have to be chosen according to the country of use.
Don't use any other configuration. Some countries need a user's licence.
See table on page 43.
Proceeding
a) Switch off the CB radio.
b) Press and hold the PTT button of the microphone and then switch on CB radio.
The letter corresponding to configuration is blinking.
c) To choose the configuration turn the channel selector rotary knob or use
buttons UP/DN of the microphone.
d) Press the PTT button of the microphone one second until the letter correspond-
ing to configuration stop blinking to confirm the configuration.
e) Switch the CB radio off in order to save.
See the configurations/ frequency bands table at pages 39 ~ 42.
A) DC-POWER TERMINAL (13.2 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 Ω, Ø 3.5 mm)
C) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel : inferior to 20 µW
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
28
: 40
: AM/FM
: from 26.965 MHz to 27.405 MHz
: 50 ohms
: 13.2 V
: 150 (L) x 165 (H) x 45 (D)
: 1.2 kg
: Microphone with support, mounting
cradle, screws
: +/- 300 Hz
: 1 W AM / 4 W FM
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 3 kHz in AM/FM
: 1.0 mV
: 1.7 A (with modulation)
: 1.8 %
: 0.5 µV - 113 dBm (AM/FM)
: 300 Hz to 3 kHz in AM/FM
: 60 dB
: 5 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 500 mA nominal
800 mA maximum
Publicité
Table des Matières
