Advice On Use - Elite QUB0 Mode D'emploi

E
A
30
E+E
A
31
A
E
32
E+E
A
33
34
ATTENTION
• Keep people, children and animals away from
the roller during use, since the moving and rota-
ting parts of the roller and the bicycle can cause
damage in case of contact.
• Before starting training, position the trainer in a
dry place, away from potentially hazardous
objects (furniture, tables, chairs, etc.) in order to
avoid any risk of inadvertent or accidental contact
with them.
• The stand is designed for use by just one cyclist.
• Check the safety and stability of the bicycle
before every training session.
• If the quick release is not compatible with the
bushings of the stand, replace it with the one
supplied (C).
• There are no individually usable components on
the inside.
• Since the feet are made from soft non-slip
material, during use they may leave rubber marks
on the floor.

ADVICE ON USE

• For less tyre wear and better grip on the roller,
it is advisable to use tyres of 23 mm width.
• Recommended rear wheel pressure: 7 -8 atmo-
spheres for racing tyres; 3.5 - 4 atmospheres for
MTB tyres. For particular cases, comply with the
pressure recommended by the tyre manufac-
turer.
• For quieter use, better grip of the tyre on the
roller and reduced vibration, use slick tyres (also
for Mountain bikes).
• Before use, clean the tyre with alcohol or water.
• If the pin of the quick release supplied protrudes
more than 3 mm from the fixing nut, cut off the
protruding part (Fig. 34).
EN
17