Unit Assembly - Elite QUB0 Mode D'emploi

EN
• Unfold the frame (A) from its packaged position
(Fig. 1) and place it on a flat surface (Fig. 2)
• There are 2 pairs of holes on its base to be used
with different roller diameter options:
1) Use the front pair of holes for a 30mm diameter
roller unit (Fig. 3);
2) Use the rear pair of holes for a 45mm diameter
roller unit (Fig. 4);
12

UNIT ASSEMBLY

ø30
• Tighten the M6 screws (D) (Fig. 5 and Fig. 6)
completely, utilizing the correct holes for the dif-
ferent roller diameter options.
1
D
ø30 diameter roller unit
2
D
ø45 diameter roller unit
ø45
3
Warning!
Warning!
4
5
6