Cooling Device - Videotec HOV Hi-PoE Manuel D'instructions

Connect the net cable to the splitter mounted inside
the housing in the slot marked POE IN. Connect the
output RJ45 cable from the splitter (slot indicated by
DATA OUT) to the camera.
POE IN
LAN
Cable
MIDSPAN
switch
Fig. 07
Splitter Hi-PoE.
Connect the net cable to the splitter mounted inside
the housing in the slot marked LAN IN. Connect the
output RJ45 cable from the splitter (slot indicated by
LAN OUT) to the camera.
LAN IN
LAN
Cable
MIDSPAN
switch
Fig. 08
Splitter PoE.
Provide the camera with a 12Vdc power supply,
preparing output wiring from the terminal indicated
by J5 on the housing board.
Fig. 09
Close the housing after the electrical connections.
6
DATA OUT DC OUT
LAN Power
Cable supply
IP Camera PCB
DC OUT LAN OUT
Power LAN
supply Cable
PCB IP Camera
J5 - Camera
power
J1 - IN
supply

6.1.3 Cooling device

This section describes how to connect the housing
with installed cooling device.
No other components need installing inside these
models, as each one is supplied complete with all the
necessary parts.
Special attention must be paid to the position of the
air intake filter fins when installing the housing.
OUT
Fig. 10
Depending on the inclination of the housing, the
direction of the fins must be such to prevent water
entering in case of rain.
To guarantee the IP44 weatherproof, install the
housing on the support following the inclination
limits as shown in the picture.
Fig. 11 Maximal rotation on the transversal axis: 0˚.
Maximal inclination on the longitudinal axis: +/- 45˚.
IN