Using The Blender; Using The Processor - Russell Hobbs 19006-56 Mode D'emploi

11. Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In this
direction, the knob is spring-loaded. When you let go, it'll return to 0.

USING THE BLENDER

1. Lower the blender jug on to the motor unit, then turn the jug clockwise, to lock it in place.
2. Remove the lid.
3. Put the ingredients into the blender jug.
4. Replace the lid.
5. Align the pips on the cap with the slots in the hole in the lid, fit the cap, and turn it clockwise to lock it.
6. Don't run the appliance without fitting the cap.
7. To add ingredients while the blender is working, remove the cap, pour the new ingredients through
the hole, then replace the cap.
8. Once finished, switch the appliance off (0) and unplug it.
9. Turn the blender jug anti-clockwise, and lift it off the motor unit.
CRUSHED ICE
1. For best results, full the jug with between 150ml and 500ml of ice cubes.
2. Put the lid on the blender, then:
Turn the speed control to Y for a second or two, then release it.
3.
4. Check the results, and adjust.

USING THE PROCESSOR

You may use the processor and disc for cutting/grating for up to 2 minutes. Any other use should be limited
to 1½ minutes. After this, let the motor rest for 2 minutes.
1. Switch the appliance off (0) and unplug it.
2. Fit the spindle to the top of the motor unit.
3. Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.
4. Choose the attachment you need.
5. Once finished, switch the appliance off (0) and unplug it.
6. Turn the jug anti-clockwise, and lift it off the motor unit.
USING THE CHOPPER/MIXER/CREAMER ATTACHMENT
Use the chopper for pulverizing ingredients.
Use the mixer to mix ingredients together.
Use the creamer to thicken cream, to beat eggs, and to cream eggs and sugar together.
1. Fit the desired attachment onto the drive shaft and slide it to the bottom.
2. Lower the drive shaft into the bowl over the spindle.
3. Put the ingredients into the jug.
4. Hold the lid with the tube slightly behind the jug handle, set it on the jug, then turn it clockwise, to
lock the tab into the top of the handle.
5. To add ingredients while the motor is running, lift the pusher out of the tube, add the ingredients
through the tube then replace the pusher.
6. To remove the lid, turn it anti-clockwise to unlock it, then lift it off.
SLICING/GRATING
1. Fit the slicer or one of the graters into the disc.
2. Lower the disc over the top of the spindle.
3. Hold the lid with the tube slightly behind the jug handle, set it on the jug, then turn it clockwise, to
lock the tab into the top of the handle.
4. Remove the pusher, and drop the ingredients down the tube.
5. Replace the pusher, and use it to push the ingredients gently down the tube.
6. Don't use fingers or cutlery to push food down the tube – only the pusher.
7. The blade(s) on top of the disc will slice or grate the food into the jug.
8. Don't let the jug get more than about half full – stop and empty it.
9. To remove the lid, turn it anti-clockwise to unlock it, then lift it off.
10. Turn the disc over, and press one of the metal ends in and down, to remove the slicer/grater.
4