Important Safeguards; Preparation - Russell Hobbs 19006-56 Mode D'emploi

Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all packaging
before use.

IMPORTANT SAFEGUARDS

Follow basic safety precautions, including:
This appliance can be used by persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been supervised/
instructed and understand the hazards involved. Children must not use or play
with the appliance.Keep the appliance and cable out of reach of children.
c To avoid injury, take care handling the blades, emptying the jug, and cleaning.
h Don't add hot liquid (over 40°C), as it may be ejected due to sudden steaming.
Misuse of the appliance may cause injury.
Unplug the appliance before assembly, disassembly, or cleaning.
Don't leave the appliance unattended while plugged in.
If the cable is damaged, it must be replaced by the manufacturer, its service
agent, or someone similarly qualified, to avoid hazard.
• Don't put the motor unit in liquid.
• Switch off (0) before fitting the jug to the motor unit.
• Switch off (0), and wait till the blades come to a stop before removing the lid from the jug, or
removing the jug from the motor unit.
• Don't put utensils into the jug while the appliance is plugged in.
• Don't use accessories or attachments other than those we supply.
• Don't use the appliance for any purpose other than those described in these instructions.
• Don't operate the appliance if it's damaged or malfunctions.
• Don't run the motor continuously for more than 1½ minutes, it may overheat. After 1½ minutes switch
off for at least 2 minutes, to recover.
DIAGRAMS
1. speed control
2. motor unit
3. spindle
4. blender jug
5. jug
6. drive shaft
7. chopper attachment
BEFORE USING FOR THE FIRST TIME
Turn to "CARE AND MAINTENANCE" and clean the appliance, to remove manufacturing dust, etc.

PREPARATION

1. Sit the motor unit on a dry, firm, level surface.
2. Route the cable so it doesn't overhang, and won't trip or catch.
3. Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.
4. Remove the lid.
5. Put the ingredients into the jug – don't fill past the max mark.
6. Put the lid on the blending jug.
7. Check that the speed control is set to 0.
8. Put the plug into the power socket (switch it on, if it's switchable).
9. Turn the speed control to the speed you want (1 = low, 2 = high).
10. Turn the speed control back to 0 to turn the motor off.
HOUSEHOLD USE ONLY
8. mixer attachment
9. creamer attachment
10. tab
11. lid
12. tube
13. pusher
14. disc
` dishwasher safe
3
15. slicing attachement
16. coarse grater
17. fine grater
18. underside of blender jug
19. blade unit
20. seal
21. cap