External Linearization - Minebea Intec Signum 2 Notice D'installation

External Linearization

Notes on Settings
External linearization can be performed
!
on verified weighing instruments only
when the menu access switch is open.
– The "external linearization" function
must be assigned to the � key
(menu item 1.9.6 or 1.9.7.).
Procedure
(
�
)
Following external linearization,
!
close the menu access switch and reset
the ) key (> 2 sec) to its previous
function (e.g., external calibration/
adjustment with user-defined weights)
under menu item 1.9.
Zero the weighing platform
Start linearization
After approx. 2 seconds, you are prompted to place the first linearization weight
on the scale.
Place the prompted weight on the scale. After a brief pause, the difference between the
measured value and the true mass is displayed.
Store the linearization weight (press ( to cancel).
You are prompted to place the second linearization weight on the scale.
Repeat the steps described above for all linearization weights.
After you store the last linearization weight, you are prompted to unload the weighing
instrument.
Unload the weighing instrument. After a brief pause, the zero point is stored
automatically and the Signum display and control unit automatically returns to the
normal weighing mode.
17
Signum Option A15