EUROM Table-heater Mode D'emploi page 12

ASSEMBLY
Remove all the packaging materials and check whether the parts
1.
of your table heater are not damaged. Also check whether all
accessories have been supplied. If something is missing or
damaged, contact your supplier.
Put the heater body upside down on a flat surface (see fig.).
2.
Slide the top from the foot (2) over the assembly brackets to the
extent that both brackets (7) fall through the correct holes in the
lid (2). Then, place the mounting plate (3) over the brackets in
the same way, in the lid. Attach the lid and plate to the heater
body using the 4 M4*20 (1) screws.
Place the foot weight (6) in the lid (2). Please note: only two of
3.
the four holes in the foot weight fit around the assembly brackets!
Place both rings (5) and the M6*20 screws (4) in the holes of the
4.
foot weight, where the assembly brackets are, and screw them in
with the Allen key provided.
Now put the tabletop upside down on the ground and put the
5.
heater body (still with the foot on top) on top of the tabletop, in
the table mount (9). The screw holes in the table mount and
tabletop have to fall on top of each other. Now attach the
tabletop onto the heater body using the four M6*8 screws (10).
Finally, turn your Outdoor table heater upright.
WORKING
Check for every use:
- or the appliance doesn't show signs of damage.
- or there are no objects, canvas, sun screens etc. are inside the
safety distances.
- or the socket you want to use gives the correct tension
(230V-50Hz). Check whether the socket is earthed and secured with
a 30mA circuit breaker.
If everything is all right you can insert the plug into the socket.
You can turn then turn the machine on using the operating button I
(one element of 800W, half power) or II (2 elements, together
1600W, full power). The button can turn on both directions. To turn
the machine off, you turn the button to 0 and remove the plug from
the socket. Allow the radiator time to cool.
In time, the glass of the heating element may colour white. This is
normal and does not affect its functioning or the lifespan of the
product.
12