CAMPAGNOLO REAR DERAILLEUR Mode D'emploi page 25

Cables and casings do not
require lubrication since they
are supplied already lubri-
cated.
• Pass the cable through the
adjustment screw (C - Fig.
10) and insert the end of the
casing; then pass the cable
underneath the plate (E - Fig.
10) and clamp it by tighte-
ning the Allen screw (D - Fig.
10) at a tightening torque
of 6 N.m - 4.4 lb.ft. Cut the
excess cable at about two
cm. from the clamping screw
and protect the end with a
cable cap.
• Position the chain on the fourth sprocket
counting from the smallest.
• Turn the cable tension adjuster (F - Fig.
11) until perfect alignment is obtained
between the centreline of the top roller
and the centreline of the fourth sprocket.
• If centering between the centrelines
of the roller and the fourth sprocket is
not correct, turn the adjuster (F - Fig. 11)
counterclockwise to shift the rear derailleur
inwards. Turn clockwise to shift the rear
derailleur outwards.
ENGLISH
10
C
D
6 N.m - 4,4 lb.ft
CLOSE
11
E
5 mmAllen wrench
F
25