CAMPAGNOLO REAR DERAILLEUR Mode D'emploi page 24

5. CABLE ASSEMBLING AND ADJUSTING
• Carry out this adjustment with the chain on
the smallest freewheel sprocket and with the
Ergopower control button zero-ed (Fig. 7).
• Tighten the screw fully by turning it
clockwise (A - Fig. 8).
• Turn the screw (B - Fig. 8) until perfect
alignment is obtained between the centre-
line of the top roller and the axis of the first
sprocket (Fig. 9).
• Check the length and, if necessary, shorten the casing. Take care to cut it straight
across without altering the configuration of the casing and without damaging the
cable in any way. If the cable is damaged, please replace it before riding your
bicycle. If the casing is too short, rear derailleur operation will be affected.
8
24
B
A
7
9
ENGLISH