Installing The Appliance - Napoleon CLEARion Elite Manuel D'installation

installation
EN
2.6

installing the appliance

note:
It is recommended to have the walls of the appliance enclosure be fi nished (i.e. drywall) to avoid exposed
insulation or vapour barrier coming in contact with the appliance. This will ensure clearance to combustibles is
maintained.
Wall anchors are not required when screwing into the wall stud.
It is recommended to use a magnetic screwdriver bit during installation to prevent the screws from falling into the
appliance.
A.
Frame the appliance along with the electrical connections.
B.
Remove the trims on both front side and back side (see "front trim installation / removal" section).
C.
Remove the glass on both front side and back side (see "front glass installation / removal" section).
D.
Install mounting bracket by aligning the edge with the centre of the stud, and 6 1/8" (164mm) from the
bottom of the wall sides (Fig. 2-1).
6 1/8" (164mm)
E.
Mark the holes for the mounting bracket. Ensure the marked holes are on opposite sides, as the brackets
cannot be mounted on the same side (Fig. 2-2).
F.
Drill marked holes and secure the mounting brackets with screws (supplied).
G.
Secure appliance to the brackets using 4 screws (supplied) and the slots from the appliance (Fig. 2-3).
H.
Install media (see "media installation" section).
I.
Reinstall front trim and glass (see "front trim installation / removal" and "front glass installation / removal"
sections).
12
W415-2107 / B / 10.31.19
Fig. 2-2
Center
of stud
6 1/8"
(164mm)
B x 4
Fig. 2-1
A x 4
B x 4
Fig. 2-3