Locating The Appliance - Napoleon CLEARion Elite Manuel D'installation

WARNING
!
• Risk of fi re! The power cord must not be pinched against a sharp edge. Secure cord to avoid tripping or
snagging to reduce the risk of fi re, electric shock, or personal injury. Do not run cord under carpeting. Do not
cover cord with throw rugs, runners, or similar items. Arrange cord away from traffi c areas and where it will not
be tripped over.
• Risk of fi re! To prevent a possible fi re, do not block air intake or exhaust in any manner. Do not use on soft
surfaces where openings may become blocked.
• Risk of fi re! Do not blow or place insulation against the appliance.
• This electric appliance is tested and listed for use only with the approved optional accessories. Use of optional
accessories not specifi cally tested for this electric appliance could void the warranty and/or result in a safety
hazard.
• If the information in these instructions is not followed exactly, a fi re or explosion may result causing property
damage, personal injury, or death. Do not store or use gasoline or other fl ammable vapors in the vicinity of this
or any other appliance.
• This appliance is heavy. It is highly recommended that two people install this appliance.
• If your appliance is equipped with a heater, ensure the heater vents cannot, in any way, be covered as it may
create a fi re hazard.
• Do not run the power cord horizontally, directly below the appliance.
Your appliance is a see-thru electric appliance installed into a wall. Select a suitable location that is not susceptible
to moisture and is away from drapes, furniture and high traffi c areas.
2.1

locating the appliance

WARNING
!
• Due to high temperatures, this electric appliance should be located out of traffi c. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes, curtains, and similar items at least 36" (91.4cm) from the
front of the appliance.
• Never locate this electric appliance where it may fall into a bathtub or other water container.
• Wear safety gloves and safety glasses for protection during installation and maintenance.
• To prevent contact with sagging or loose insulation, the electric appliance must not be installed against vapor
barrier or exposed insulation. Localized overheating could occur and fi re could result.
• Do not expose the electric appliance to the elements (such as rain, etc.).
To determine the front of the appliance, ensure the junction box is located on the left side of the appliance and the
triangular covers are located on the other side of the fi rebox (see below).
For illustrative purposes only.
Appliance may not appear
exactly as illustated.
Junction
Box
note:
Follow all national and local electrical codes.
Triangular
Cover
2.0 installation installation
Front
View
W415-2107 / B / 10.31.19
EN
9