Napoleon CLEARion Elite Manuel D'installation page 21

Ember Bed
Colour
Flame Speed
Heater
Timer
Temperature
Control
operating instructions
Controls ember bed light settings.
NOTE: Ember bed brightness must be between B-4 and B-1
to control ember bed colour.
Settings:
L01 - Orange
L02 - Red
L03 - Blue
L04 - Yellow
L05 - Green
L06 - Purple
L07 - Sky Blue
L08 - Purple Red
L09 - White
L10 - Pink
L11 - Yellow Green
L12 - Ice Blue
L13 - Orange Red
L14 - Light Green
L15 - Magenta
L16 - Autocycle
L17 - Lock a colour during L16 cycle
Controls fl ame speed.
Settings: 3-4-5-1-2.
Turns the heater and blower on/off.
Settings:
H-0 - Heater and blower off
FAN - Blower on
H-1 - Heater on
(750W each side @ 120V / 1500W each side @ 240V)
LcK - Lock-out of heater and thermostat
NOTE: Press and hold the heater button for 5 seconds to
lock / unlock the heater and thermostat.
NOTE: Each side of the appliance has an independent heater
control.
Sets the timer.
Settings:
30M, 1Hr, 2Hr, 3Hr, 4Hr, 5Hr, 6Hr, 7Hr, 8Hr.
NOTE: The display will read "---" after completing the 9 timer
settings.
Sets desired temperature.
Settings:
64°F (18°C), 66°F (19°C), 68°F (20°C), 70°F (21°C), 72°F
(22°C), 74°F (23°C), 76°F (24°C), 78° (25°C), 80°F (26°C),
82°F (27°C), and OFF.
To switch between °F and °C or vice versa, hold the tempera-
ture control button for 5 seconds.
EN
21
W415-2107 / B / 10.31.19