Programming; Keypad Mode - Nice MORX Mode D'emploi

5) Programming

Two different programming modes can be used for each MOON
access control system regardless of whether KEYPADS or READERS
and relative CARDS are used:
EASY: simple programming mode featuring basic code entry
and cancellation functions.
PROFESSIONAL: for professional programming featuring
more specific functions.
Depending on whether KEYPADS or a READER and relative CARD are used, operating and programming methods are totally
different; from this point on, therefore, the instructions manual is divided into two parts:
Use and programming in the KEYPAD mode (chapters 5.1-5.4)
Use and programming in the CARD mode (chapters 5.5-5.8)

5.1) KEYPAD mode

The KEYPAD mode is based on "combinations", that is, the 1 to
9 digit numbers that users must enter by pressing the various
numerical keys. After the number has been entered press the
confirmation key or to activate the output. Of course, only if
the combination is valid will the output relay be activated; if the
combination is incorrect, an error tone will be heard.
After three consecutive incorrect combinations, the system will
The two modes only differ in the programming phase and the level of
performance obtained; these differences are negligible for users.
The choice between one mode and the other must be made while the
memory is empty and depends on which programming mode is used to enter
the first combination or CARD.
After choosing between the EASY or PROFESSIONAL programming mode,
this cannot be modified unless the memory is completely deleted.
block for 1 minute.
The combination must be completely correct; if, for example, the
correct one is , the following will be considered
incorrect:
, ,
when entering a combination, press the confirmation keys
immediately and enter the exact combination after the incorrect
combination tone has finished.
. Therefore, if an error is made
or
GB
13