Professional Mode Card Programming - Nice MORX Mode D'emploi

Table "E5" Delete memory
This function deletes all the data contained in the memory, thereby making it possible
to choose between the EASY and PROFESSIONAL modes once more
1. Press and hold down the small button on the DECODER, the LED lights up for 3 seconds
and then flashes 3 times.
2. Release the button exactly during the third flash.
N.B.: If the operation was performed correctly, the LED will flash 5 times after a few moments.

5.8) PROFESSIONAL mode CARD programming:

PROFESSIONAL mode programming allows complete management
of all functions directly from the READER by means of the MASTER
CARD. It is possible to enter new CARDS, cancel them, count them,
delete the whole memory and use other specific functions. It is also
possible to establish the function of the output relays, choosing
between MOMENTARY, BISTABLE, TIMER and ANTI-THEFT.
In this mode one or two CARDS must be reserved as MASTERS (see table
F1 and F2) which must be used for all programming phases. THE MASTER
CARDS are normal CARDS that are the first to be inserted when the memory
is still empty. Once it has become a MASTER, a CARD is only valid for
programming and cannot be used to activate outputs.
MASTER CARDS can be used in other systems as normal CARDS or as
MASTERS.
32
!
MASTER CARDS are indispensable for all programming
phases and cannot be cancelled except when the whole
memory is being deleted. It is vital not to lose these
CARDS.
Each DECODER can memorise 2 MASTER CARDS,
• Master 1: manages the CARDS that will activate output N°1 with
the STATIC 1 option
• Master 2: manages the CARDS that will activate output N°2 with
the STATIC 2 option.
The purpose of the two MASTERS is to organise two completely
separate groups of CARDS that can activate only one of the outputs.
Moreover, each MASTER can only add or cancel CARDS belonging
to its group. This division is useful in a 2-family building, for example.
If this division into 2 groups is not required, the same CARD can be
Example