Mettler Toledo IND560 Guide D'installation page 54

IND560 Installation Manual
Consult
PROFIBUS (Harsh Enclosure)
Connection to the PROFIBUS board in the harsh enclosure (Figure 2-41) is made
using a right-angle nine-pin connector inside the IND560 enclosure. This
connector is a standard Siemens part # 6ES7 972-0BA41-0XA0 or equivalent; it is
not supplied by METTLER TOLEDO.
2-26
NOTES:
1. CONNECTION WITH 2 TWISTED PAIR SHIELDED CABLE
BELDEN 3082A OR 2083A OR EQUIVALENT.
2. REFER TO O.D.V.A. DEVICENET DOCUMENTATION FOR
OTHER CONSIDERATIONS.
3. WIRE SIZE: 14 AWG (2.088 mm2) MAXIMUM
Figure 2-40: DeviceNet Connector Wiring
http://www.odva.org/ for additional DeviceNet wiring information.
Figure 2-41: PROFIBUS Option Board, Harsh Enclosure
22 AWG (0.322 mm2) MINIMUM.