Mettler Toledo IND560 Guide D'installation page 29

Chapter 2.0
Installation
This chapter covers
• Opening the Enclosures
•
Environmental Protection
• Mounting the Terminal
•
Installing Cables and
Connectors
•
PCB Switch Settings
• PCB Jumper Positions
• Capacity Label Instructions
•
Sealing the Enclosure
IF YOU WISH TO INSTALL THE IND560 IN A DIVISION 2 OR ZONE 2/22 AREA, REFER TO THE
DIVISION 2 AND ZONE 2/22 INSTALLATION INSTRUCTIONS INCLUDED ON THE RESOURCE CD
PROVIDED WITH THE TERMINAL. FAILURE TO COMPLY WITH THE INSTRUCTIONS PROVIDED
THERE COULD RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A, B, C, AND D;
CLASS II GROUPS F AND G; CLASS III; HAZARDOUS LOCATIONS OR NON-HAZARDOUS
LOCATIONS ONLY.
DO NOT INSTALL, DISCONNECT OR PERFORM ANY SERVICE ON THIS EQUIPMENT BEFORE
POWER HAS BEEN SWITCHED OFF OR THE AREA HAS BEEN SECURED AS NON-HAZARDOU BY
PERSONNEL AUTHORIZED TO DO SO BY THE RESPONSIBLE PERSON ON-SITE.
ONLY THE COMPONENTS SPECIFIED IN THIS MANUAL CAN BE USED IN THIS TERMINAL. ALL
EQUIPMENT MUST BE INSTALLED IN ACCORDANCE WITH THE INSTALLATION INSTRUCTIONS
DETAILED IN THIS MANUAL. INCORRECT OR SUBSTITUTE COMPONENTS AND/OR DEVIATION
FROM THESE INSTRUCTIONS CAN IMPAIR THE SAFETY OF THE TERMINAL AND COULD RESULT
IN BODILY INJURY AND/OR PROPERTY DAMAGE.
This chapter provides installation instructions for the IND560 terminal
panel-mount and harsh enclosures. Please read this chapter
thoroughly before beginning installation.
DIV 2 AND ZONE 2/22 INSTALLATION
WARNING!
WARNING!
WARNING!
2-1