Wearing The Udirect 2 Correctly; Testing Sound Via The Udirect 2 - Unitron uDirect 2 Ensemble Guide

Wearing the uDirect 2 correctly
Before any phone, music
or TV streaming can take
place, the uDirect 2 must
be switched ON and worn
correctly as shown below:
1. Put the neckloop
around your neck (easily done by
unplugging one neckloop plug).
2. Make sure both plugs are well
connected in the neckloop sockets.
3. Switch the uDirect 2 ON.
For streaming, the neckloop must always be
plugged in. When unplugged, the uDirect 2
will go into sleep mode after two minutes.
The power and audio indicators will stop
blinking and all active Bluetooth connections
are terminated to save power. Plug the
neckloop in again to activate the streaming.
8
Testing sound via the uDirect 2
1. Wear the uDirect 2 correctly and switch it ON.
2. Press and hold the connect
( ) and access ( ) buttons
simultaneously for 2 seconds until
the audio indicator turns violet.
The hearing aids will switch to the
streaming mode and you will hear the
uDirect 2 sound demo for 30 seconds after
the last volume adjustment.
Use the ( ) buttons to adjust the volume.
The sound demo will stop 30 seconds after the last
volume adjustment or by pressing any other key.
If you cannot hear the sound demo:
Make sure your hearing aids are inserted
correctly.
Make sure the uDirect 2 neckloop is properly
plugged in on both ends and worn around
your neck.
Make sure the uDirect 2 is charged and
switched ON.
Make sure you are not on a phone call
connected through the uDirect 2.
9