Unitron uDirect 2 Ensemble Guide page 30

Cause
The caller can hear me but I cannot hear the caller
The call was transferred
to your phone
The volume of the music is too loud or too quiet.
The volume of phone conversations is not comfortable
(too low or too high)
Different audio sources
have different outputs
uDirect 2 is no longer recognized by the phone or other
Bluetooth device to which it was previously paired
2 minutes after no
device was found,
uDirect 2 stops seeking
devices to save power
The devices are too far
away from each other
52
Possible remedy
Make sure the call is
transferred back to uDirect 2
via the phone menu or long
press of ( ) button
Reduce the hearing aid volume
by pressing the button.
If the sound volume over
the phone (or music) is too
low after this reduction use
the phone volume button to
increase volume
Switch uDirect 2 OFF, wait until
the red indicator switched off,
then turn device ON again
Bring devices within 1 meter
of each other and try again
Cause
uDirect 2 can be paired
to a maximum of 8
different Bluetooth
devices. If the internal
memory is full, new
pairings may overwrite
previous pairings
Pairing was deleted
I am not streaming but the hearing aids keeps
switching between Bluetooth and the normal hearing
aid program
Your phone sends
sounds to uDirect 2 due
to incoming SMS or
mails
Phone key tones are
switched on
I hear my phone's key-press tones in my hearing aids
The key-press tones
may be enabled on
your phone
Possible remedy
Repeat the pairing between
uDirect 2 and the Bluetooth
device which was over-written
Repeat the pairing between
uDirect 2 and the Bluetooth
device which was deleted
Disable the system sounds for
reminders, alarms, SMS, etc.
via your phone menu
Switch off phone key tones via
your phone menu
Deactivate key-press and
confirmation tones on your
phone. Please refer to the
phone's user guide
53