Unitron uDirect 2 Ensemble Guide page 15

the person's name instead of typing the
number.
When using two phones at the same time
(multi point) only the last paired phone can
be used for voice dial.
3. Hold call
While in a phone conversation, a long press
of the connect (
on hold. The caller stays on the line but there
is no audio transfer and the hearing aids
switch to the previous hearing program. Use
this mode to have a side conversation with a
person next to you without transmitting the
conversation to the person on the phone.
4. Transfer call
While in a phone conversation, a long press of
the access ( ) button will transfer the call to
the phone. This allows you to hand your phone
to another person. Your hearing aids will
switch back to the previous hearing program.
After holding or transferring a call, another long
press of the access ( ) button transfers the call
back to the uDirect 2 and the call is resumed
through your hearing aids.
22
) button will put the call
As long as the call is on hold or transferred,
you may use the access ( ) button to change
your hearing aid programs again.
Using the external microphone
Use the optional external
lapel microphone "MC1"
if you wear the uDirect 2
underneath clothing during
a phone call.
1. Plug the 3.5mm
microphone plug into
the audio input of the
uDirect 2, disabling
the internal uDirect 2
microphones.
2. Use the clip to place the
omnidirectional microphone as close to your
mouth as possible.
3. Put the neckloop around your neck and switch
the uDirect 2 ON.
Jackets, etc., will not negatively influence
the wireless link to your hearing aids.
23