Unitron uDirect 2 Ensemble Guide page 26

8. Your phone may then ask you to enter a
passcode. If so, enter "0000" (four zeros).
Some phones may ask which Bluetooth
service you want to enable. Select "Headset"
or, if available, "Stereo Headset".
9. Your uDirect 2 should now be paired to your
phone and the audio indicator will stop blinking.
The pairing process is independent of the
neckloop (it does not need to be plugged in).
It may be necessary to redo the pairing if your
phone's firmware was updated.
How to connect to a phone
Once your phone and uDirect 2 are paired (see
Pairing a Bluetooth-enabled phone), the phone
needs to be 'connected' to your uDirect 2 before
it will actually send audio signals to it.
This function should also appear in your phone's
Bluetooth menu.
1. Ensure that the uDirect 2 is turned ON and the
neckloop is plugged in and worn correctly.
2. Locate the Bluetooth section in your phone
menu and select list of "paired devices".
44
3. Locate and highlight your uDirect 2 and
select "Connect".
4. Confirmation of successful connection
is indicated on the uDirect 2 by the audio
indicator blinking blue. Additionally a
headset symbol ( ) may appear on the
main screen of your phone.
The connection between your uDirect 2 and
your phone will be maintained as long as the
two devices remain on and are within range
of each other. If either device is switched off
or moves out of range, you may need to repeat
the connection procedure.
Some phones may perform the connection
procedure automatically after pairing. We
recommend selecting "Yes" when prompted to
allow this device to connect automatically once
the pairing is completed.
Please consult your phone's user guide in the
case where a manual connection is necessary.
Pairing with other external Bluetooth devices
If you want to use your uDirect 2 to listen to music
from your stereo system you may use an external
45