Unitron uDirect 2 Ensemble Guide page 13

appropriate language setting for proper
pronunciation of the names. Your hearing
healthcare professional may switch the caller
identification off upon your request.
Accepting incoming calls
To accept an incoming call, briefly press the
access ( ) button on your uDirect 2 once you
hear the ringtone through your hearing aids. It
will take about 5 seconds before you hear the
ringtone through your hearing aids.
Speak into the uDirect 2, not into the phone,
when the call is in progress.
For your safety, the hearing aid microphones
will remain on at reduced levels during phone
calls and audio streaming.
Only one phone call at a time is possible. A
second ringing phone is ignored while another
call is already connected.
18
"click"
Making phone calls
Make sure the uDirect 2 and
your phone are connected
through Bluetooth as
described on page 42.
Use the phone keypad to
enter the number and press
the phone dialing button.
When connected, you will hear the dialing tone
through your hearing aids after approximately
3 seconds.
Using cordless phones (DECT) or older phones
with headset profile only
If your phone only supports the headset
profile (HSP), the connection must be initiated
manually for outgoing calls. This often applies
to cordless home phones (DECT standard).
For these phones, the audio indicator might
not blink blue even if the phone is paired.
1. Dial the number you want to dial on your
phone, or select it from the phone book.
2. Briefly press the connect (
wait 5 seconds.
) button, then
19