Unitron uDirect 2 Ensemble Guide page 27

Bluetooth transmitter. The uDirect 2 can also be
used with a Bluetooth-enabled landline phone.
The pairing procedure for other Bluetooth
devices is controlled by the device with which
you are attempting to pair. The procedure for
pairing may vary for each device. Please refer
to the device's user guide or dealer support
if you cannot complete the pairing procedure
with the generic steps described below.
1. Turn ON both uDirect 2 and the other device.
2. Place them next to each other.
3. Set your device into Bluetooth pairing mode.
4. Initiate the pairing process on your uDirect 2
by simultaneously pressing the (
buttons for 2 seconds until the audio
indicator is rapidly blinking blue.
5. Your uDirect 2 will remain in the pairing
mode for two minutes or until the pairing
is completed.
6. If a passcode is required, enter "0000"
(four zeros).
After pairing, wait until the devices have
completed connection.
46
Confirmation of successful connection is
indicated on the uDirect 2 by the audio indicator
shortly blinking blue. A double-blink indicates
that two devices are connected to uDirect 2.
Deleting the pairing of Bluetooth devices
If you encounter issues with one of the paired
devices, or if a device stops connecting to your
uDirect 2, you may consider deleting the pairing
of devices to the uDirect 2.
1. Turn ON your uDirect 2.
2. Press and hold the (
) and ( )
Deleting the pairing of Bluetooth devices
removes the ability to connect to these devices.
You will need to perform the pairing process
again if you wish to reconnect.
10 seconds until the blue rapid blinking audio
indicator stops.
) and ( ) buttons for
47