Safety First; Indications - Ivoclar Vivadent Programat CS Mode D'emploi

This chapter is especially important for personnel
who work with the Programat CS or who have to
carry out maintenance or repair work. This chapter
must be read and the corresponding instructions
followed.

2.1 Indications

The Programat CS must only be used to fire dental
ceramic materials and it should be used for this
purpose only. Other uses than the ones
stipulated, e.g. cooking of food, firing of other
materials, etc. are contraindicated. The
manufacturer does not assume any liability for
damage resulting from misuse. The user is solely
responsible for any risk resulting from failure
to observe these Instructions.
Further instructions to assure proper use of the
furnace:
– The instructions, regulations, and notes in these
Operating Instructions must be observed.
– The instructions, regulations, and notes in the
material's Instructions for Use must be observed.
– The furnace must be operated under the
indicated environmental and operating
conditions (Chapter 9).
– The Programat CS must be properly
maintained.

2. Safety First

2.1.1
Contraindication
2.1.2
Contraindication
2.1.3
Contraindication
2.1.4
Contraindication
2.1.5
Contraindication
9
Do not carry the furnace head by
the cooling tray.
Do not carry the furnace head by
the cables, since the cables and
connections may be damaged.
The furnace head should not be
removed from the furnace base as
long as the furnace head is
connected by means of the
heater cable.
The furnace has an electric drive
and must be operated by means
of the electronic controls. Never
open the furnace head by hand,
since the mechanism will be
damaged.
Do not touch the thermocouple
and the quartz tube in the firing
chamber. Avoid contact with the
skin (grease contamination), as
the parts will be prematurely
damaged.