Introduction / Signs And Symbols; Preface; Introduction; Notes Regarding The Operating Instructions - Ivoclar Vivadent Programat CS Mode D'emploi

1. Introduction / Signs and Symbols

1.1 Preface

Dear Customer
Thank you for having purchased
the Programat CS. It is a
state-of-the-art furnace for the
dental practice, which requires a
furnace for the CAD/CAM
technique. The Programat CS
enables glaze and crystallization
firings for the CAD/CAM
technology. This furnace has
been specially developed for
this purpose.
The furnace has been designed
according to the latest industry
standards. Inappropriate use
may damage the equipment and
be harmful to personnel. Please
observe the relevant safety
instructions and read these
Operating Instructions carefully.
Enjoy working with the CS.

1.2 Introduction

The signs and symbols in these
Operating Instructions facilitate
the finding of important points
and have the following
meanings:
Risks and dangers
Important
information
Contraindication
Burn hazard
Risk of crushing
1.3 Notes regarding the
Operating Instructions
Furnace concerned:
Programat CS
Target group:
Dentists and dental
technologists
These Operating Instructions
facilitate the correct, safe, and
economic use of the Programat
CS furnace.
Should you lose the Operating
Instructions, extra copies can be
ordered at a nominal fee from
your local Ivoclar Vivadent
Service Center.
1.4 Notes on the different
voltage versions
The furnace is available with
different voltage versions.
– 100 V / 50–60 Hz
– 110–120 V / 50–60 Hz
– 200–240 V / 50–60 Hz
In the Operating Instructions,
the furnace is described in the
200-240 V voltage version.
Please note that the voltage
range shown on the images
(e.g. rating plate) may differ
depending on the voltage
version of your furnace
8