Introduction/Signs And Symbols; Preface; Introduction; Notes Regarding The Operating Instructions - Ivoclar Vivadent Gnathometer CAD Mode D'emploi

1 Introduction/Signs and Symbols

1.1 Preface

Dear Customer,
Thank you for having purchased the "Gnathometer CAD".
It is a highly-technical quality instrument. This product is
distinguished for its good quality and high precision.
The Gnathometer CAD has been designed according to the
latest industry standards. Inappropriate use may damage the
equipment and be harmful to personnel. Please observe the
relevant notes and read the Operating Instructions.
Enjoy working with Gnathometer CAD.

1.2 Introduction

The signs and symbols in these Operating Instructions
facilitate the finding of important points and have the
following meanings:
Important information
Risks and dangers
Contraindication

1.3 Notes regarding the Operating Instructions

Device concerned: Gnathometer CAD
Target group: Dentists, dental professionals
These Operating Instructions facilitate the correct, safe and
economical use of the Gnathometer CAD.
Should you lose the Operating Instructions, extra copies can
be ordered from the respective Service Centre or downloaded
as PDF from the internet.

2 Safety First

We recommend this chapter to all individuals working with
the device or perform cleaning and maintenance work.

2.1 Indications

When manipulating the Gnathometer CAD while it is
attached to the patient, make sure that the tongue of the
patient is not injured by the stylus of the registration pin.
Risks and dangers:
2.1.1 Risk of swallowing and choking hazard:
Warning:
Since there are small components that may fall off
if not attached correctly, there is a risk of
swallowing these parts.
2.1.2 Risk of injury
Warning:
To prevent injury by the registration pin, the
patient must be instructed to slide the tongue
below the registration plate.

2.2 Health and safety instructions

Gnathometer CAD must only be used for the purpose
described in Chapter 3. Further instructions to assure proper
use of Gnathometer CAD:
The instructions, regulations, and notes in these
Operating Instructions must be observed.
Gnathometer CAD must be properly maintained (see
Chapter 7).
17