Technical Information - Meister MPH1500-1 Traduction Du Manuel D'utilisation Original

Improper use of the product
All applications carried out with the
device that are not listed in the "Proper
use" chapter will be considered
improper use.
Uses for which the tool is not designed
may cause risks and injury. Do not
use accessories that are not intended
specifically for this electrical tool.
Just because you can affix an accessory
to your electrical tool, there is no
guarantee it is safe to use.
The permitted revolutions of the tool
insert must be at least as high as the
highest value specified on the electrical
tool. Accessories that turn faster than is
permitted may break and fly away.
The external diameter and thickness
of the tool insert must match the
dimensions of your electrical tool.
Incorrectly measured tool inserts cannot
be properly protected or checked.
There is a risk of injury. The user of
the device is liable for all property and
personal damages occurring as the
result of incorrect use.
If other components or non­original
components are used with the machine,
the manufacturer guarantee is voided.
Remaining risks:
The operating instructions for this
electrical tool contain comprehensive
tips for the safe handling of electrical
tools. However, every electrical tool
has a certain level of remaining risks
which cannot be excluded by the
protective mechanisms on the device.
Always operate electrical tools with the
necessary care.
MW-5452860-Bedien-2008.indd 43 MW-5452860-Bedien-2008.indd 43
Remaining risks may be, for example:
• Touching rotating parts or tools.
• Injury caused by flying tools or tool
parts.
• Risk of fire with insufficient ventilation
of the motor.
• Adverse effects on the hearing caused
by working without ear defenders.
The ability to work safely is dependant
on the familiarity of the operator when it
comes to handling the given electrical tool.
Appropriate knowledge of the machinery
and careful behaviour when working help
to minimise the remaining risks.
5 – Technical information
Technical data
Power supply
Nominal consumption 1500 W
Speed
Number of blows
(without load)
Maximum drill diameter
- in wood
- in cement/stone/
granite
- in steel
Weight
Cable
We reserve the right to make technical
changes.
is a registered trademark of
Conmetall Meister GmbH,
42349 Wuppertal, Germany
230 V­/50 Hz
n = 0-850 min -1
0
0­3900 min /4.0 J
-1
40 mm
32 mm
13 mm
5.6 kg
300 cm
43
24.08.20 13:10 24.08.20 13:10