Technical Data - Hilti DC-SE 20 Mode D'emploi

Technical data

Voltage:
Nominal current:
Nominal power:
Mains supply frequency:
Max. disc diameter:
Supply cord length:
Weight in accordance with EPTA procedure
01/2003:
Electronic no-load speed limit:
Current overload protector:
Integrated start-up current overload protector: Yes
Motor thermal overload protector:
Double insulation, class II Z:
NOTE
The vibration emission level given in this information sheet has been measured in accor-
dance with a standardised test given in EN 60745 and may be used to compare one tool
with another. It may be used for a preliminary assessment of exposure. The declared vibra-
tion emission level represents the main applications of the tool. However if the tool is used
for different applications, with different accessories or poorly maintained, the vibration emis-
sion may differ. This may significantly increase the exposure level over the total working
period. An estimation of the level of exposure to vibration should also take into account the
times when the tool is switched off or when it is running but not actually doing the job. This
may significantly reduce the exposure level over the total working period. Identify additio-
nal safety measures to protect the operator from the effects of vibration such as: maintain
the tool and the accessories, keep the hands warm, organisation of work patterns.
Noise and vibration information (measured in accordance with EN 60745):
Typical A-weighted sound power level
Typical A-weighted emission sound pressure
level
Uncertainty for the given sound level
Triaxial vibration values (vibration vector sum)
Triaxial vibration values
Uncertainty (K)
Right of technical changes reserved
Printed: 14.02.2014 | Doc-Nr: PUB / 5069486 / 000 / 02
100 V 110 V 230 V 240 V
– 16 A 9,2 A 8,8 A
1700 W 1700 W 1950 W 1950 W
50–60 Hz
125 mm
5 m
6,9 kg
7500 /min
Yes
Yes
Yes
115 dB (A)
104 dB (A)
3 dB (A)
5.8 m/s 2
1.5 m/s 2
User information as per EN 61000-3-11
Switching operations cause short voltage drops. If the mains electric supply conditions are
unfavourable, other tools / machines can be impaired. If the main electric supply impedance
is less than 0.15 Ohms, no disruptions / disturbances need be expected.
13