Technical Data; Product Properties - Hilti DX 76 Mode D'emploi

• It is a requirement for the remaining countries that the cartridges must have passed the firing-residues
test in accordance with EN 16264 and must have a manufacturer's declaration to this effect.
Cartridges (as example: X-ENP)
Comply with the instructions for use in the operating instructions of the fastener used, in the Hilti
Direct Fastening Technology Manual or the corresponding local Hilti 'Technical Guide to Fastening
Technology'.
Ordering designation
6.8/18M cartridge
3.4 Minimum distances and edge distances
You must always observe certain minimum distances and spacing when driving fasteners. They can differ,
depending on the product.
Comply with the instructions for use in the operating instructions of the fastener used, in the Hilti
Direct Fastening Technology Manual or the corresponding local Hilti 'Technical Guide to Fastening
Technology'.
3.5 Information about the field of applications
For detailed information about areas of application, request a copy of the Hilti 'Direct Fastening Technology
Manual' or the corresponding local Hilti 'Technical Guide to Fastening Technology' from your Hilti Store.
4

Technical data

4.1

Product properties

Weight (fastening tool with magazine)
Dimensions
Magazine capacity
Recommended maximum fastening rate
Max. contact pressure
Compression stroke
Ambient temperature (storage and use)
*282472*
282472
Color Power level
(charge)
black extra-strong
red very strong
blue strong
green Extra-light
4.35 kg
450 mm × 101 mm × 352 mm
10 fasteners
600 fastener driving opera-
tions/h
≤ 240 N
32 mm
−15 ℃ ... 50 ℃
English 5