Technical Data - Hilti BX 3-BT Notice D'utilisation Originale

Status
The LED flashes green every 3 seconds.
The LED flashes steadily green.
The LED flashes red.
The LED shows red.
The LED flashes yellow.
3.5 Indication of battery charge status
When one of the battery release buttons is pressed, the display indicates the battery's state of charge.
Reliable indication of the charge status is not possible while a fastener is being driven or immediately
after a fastener is driven.
Status
All four LEDs show green.
Three LEDs show green.
Two LEDs show green.
One LED shows green.
One LED flashes green.
3.6 Items supplied
BX 3-BT fastening tool, X­FG B3 series fastener guide, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

4.1 Fastening tool
Weight including battery
Threaded-stud length
Thread diameter
Compression stroke
Contact pressure
Application temperature (ambient temperature)
*2209577*
Meaning
The fastening tool is in stand-by mode. Press the
nose of the tool against the working surface to
switch it on
The fastening tool is too hot or the battery has in-
sufficient power; see "Troubleshooting"
Malfunction; see "Troubleshooting"
Malfunction; see "Troubleshooting"
Bring the fastening tool to Hilti Service.
Meaning
Charge status is 75 % to 100 %.
Charge status is 50 % to 75 %.
Charge status is 25 % to 50 %.
Charge status is 10 % to 25 %.
Charge status is below 10 %.
B 22/2.6 Li-Ion (02)
B 22/3.0 Li-Ion (01)
B 22/4.0 Li-Ion
B 22/5.2 Li-Ion (01)
B 22/8.0 Li-Ion
2209577
4.0 kg
(8.8 lb)
4.1 kg
(9.0 lb)
4.2 kg
(9.3 lb)
4.3 kg
(9.5 lb)
4.6 kg
(10.1 lb)
31 mm
(1.2 in)
8 mm ... 10 mm
(0.3 in ... 0.4 in)
12 mm
(0.5 in)
50 N ... 70 N
(11 lb ... 16 lb )
f f
−15 ℃ ... 50 ℃
(5 ℉ ... 122 ℉)
English 7