Tare; Continuous Display Of Measured Result (Hold) - Seca 757 Mode D'emploi Et Garantie

Continuous display of
measured result (HOLD)
1. Place the additional weight on the tray.
2. Hold down the (hold/tare) arrow key until the
hold
message "NET" appears in the display.

tare

3. Wait until the display stops flashing and is replaced
by 0.000.
4. Place the baby on the tray.
5. Read off the measured result.
The additional weight has been deducted
automatically.
6. To disable the TARE function, press the (hold/tare)
hold
arrow key until the message "NET" is no longer dis-
tare
played or switch off the scale.
NOTE
The maximum weight which can be displayed is
reduced by the weight of the objects already
placed on the scale.
If you activate the HOLD function, the weight value
continues to be displayed after the load has been
removed from the scale. This allows you to attend to
the baby before noting down the weight.
1. Place the load on the scale.
2. Briefly press the (hold/tare) arrow key.
hold
tare
The display flashes until a stable weight is meas-
ured. The weight value is then displayed continu-
ously. The
the message "HOLD" are displayed.
3. To disable the HOLD function, briefly press the
hold
(hold/tare) arrow key.
tare
The
longer displayed. 0.000 appears in the display. You
can perform another weighing operation if required.
NOTE
If the Autohold function is activated, the
weighed value will automatically be displayed
continuously (see section entitled "Activating
the Autohold function (Ahold)" on page 64).
symbol (non-calibratable function) and
symbol and the "HOLD" message are no
English
Operation • 61