shark EvoLine 3 Série Mode D'emploi page 24

24 TExTILEs ParTs
rEPLaCInG ThE InTErIor PaDDInG
- Start the operation by sliding the plastic
tabs of the front of the head section in its
housing beginning with one side (Fig. A);
- Position the padding correctly inside the
top of the helmet;
- Attach the two press studs on the rear
part of the head section (Figs. B – C);
- Reposition the cheek pads by passing
the chin straps through the slit in the foam
(Fig. D);
- Attach the 3 press studs and then the
Velcro band;
- Insert one end of the neck pad at the
edge of the helmet, and feed the remainder
of the neck pad beneath the edge of the
helmet. Insert the other edge of the neck
pad at the other edge of the helmet. Be
sure that the neck pad is not upside down.
warnInG! The interior padding is cri-
tical to maintain the correct fit of
the helmet on your head. If you have any
doubt whatsoever regarding the removal or
replacement of the interior padding, Do noT
usE Your hELmET. Contact your retailer
for assistance or advice. nEVEr use your
helmet with any part of the interior padding
removed. The helmet will not protect you in
an accident.
warnInG! The polystyrene lining and
interior padding are critical to properly
fit your helmet on your head. an improper
fit could cause your helmet to become dis-
lodged in an accident, leaving your head
unprotected and resulting in severe head
injury or death. If you are not sure that you
properly replaced the comfort padding, Do
noT usE Your hELmET. Contact your retailer
for assistance or advise.
erManualEvoCarbon.indd 24
a
B
D
C
24/07/14 16