shark EvoLine 3 Série Mode D'emploi page 17

oPEn FaCE / FuLL FaCE
ard
This transformation is equally easy. If your
will
visor is in the lower position, lift your visor (Fig
nd
cs.
A) by pushing its central catch upwards. Then,
on,
take hold of the chin bar on the left side (Fig B)
h a
with the thumb and forefinger
B
erManualEvoCarbon.indd 17
oPEn FaCE /FuLL FaCE
and tilt it forward (Fig C-D). Caution: DO NOT
PUSH THE RED BUTTON ON CHIN BAR when
operating; it might damage the surface of the
helmet. Once the chin section is in the low
position, push it slightly backward until it locks
with a "click" (Fig E).
a
D
17
C
clic!
E
24/07/14 16