Timer Menu - Hayward HCP3000 Série Guide D'utilisation

Low Temp Operation
12.
Disabled
13.
Password Protection
Disabled
Note: See section 6.13 for details on Password Protection configuration.
14.
Low Temp Speed
1000 (600-3450rpm)
15.
Drive Temp Setting
5ºC (41.0ºF)
Note: When the pump is stopped and the internal motor drive temperature reaches the operation temperature set
point, then the pump will prime and then run according to the set speed until the internal drive temperature
becomes 10° F higher than the temperature set point. The internal drive temperature does
ambient outside temperature. Low temperature operation is
Low temperature operation is NOT intended to protect the pump, system plumbing, or pool from freezing. If Low
Temp Operation is disabled, the speed and temperature setting screens are not shown.
Reset all parameters
16.
+ for yes; > to skip
17.
Are you sure?
+ for yes; - for no
18.
Use Timers Menu to
set timeclocks.

6.7 Timer Menu

1.
Timer Menu
Press > to enter
2.
Timer 1
12:00a to 11:45p
3.
Press + to change;
Press > next timer
4.
T1: Timer 1
+/- rename;
Page 21 of 76
Screen
1725rpm
speed >
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
HCP3000 SERIES Variable Speed Pump
+ -
Enable or Disable Low Temp Operation
< >
Move to next menu item
+ -
Use to enable or disable password protection
< >
Move to next menu item
+ -
Set pump speed for Low Temp Operation
< >
Move to next menu item
+ -
Set temperature to activate Low Temp Operation
< >
Move to next menu item
not
active when the pump is being remotely controlled.
+ -
Use + to reset to factory default settings
< >
Use > to skip reset
+ -
Confirm reset of all parameters
< >
Move to next menu item
Buttons
Used Comments
< >
Use > to enter Timer Menu
+ -
Use + to change displayed timer
< >
Use > to skip to next timer
+ -
Use + to rename timer
< >
Use > to set motor speed for timer
not
correlate to the
ISHCP3000VSPC Rev -B