Configuration Menu - Hayward HCP3000 Série Guide D'utilisation

6.6 Configuration Menu

1.
Configuration Menu
2.
Configuration Menu
press > to enter
3.
Use + / - to adjust,
> go to next item
4.
Time:
+ change
5.
Set Day and Time
Thursday
6.
Speed Selection
7.
MAX allowed speed
3250 (600-3450rpm)
8.
MIN allowed speed
600 (600-3450rpm)
9.
Prime Duration
8:00 minutes
Note: User may set the pump to prime at the maximum allowed speed for 0-15 minutes in 30 second increments.
10.
Remote Control Mode
Standalone/Hayward
Note: See sections 5.3 and 5.4 for more detail.
11.
Set Comm Bus Address
Pool Filter
Note: The pump can be controlled by a Hayward control through the Comm Bus, or by a third party control using
relay contacts to select speeds set in the Timer Menu. When communicating with Hayward controls other than
OmniLogic, a bus address must be chosen for the pump. When communicating with OmniLogic, the Comm Bus
Address screen is not shown and the HUA (Hayward Unique Address) is used. If Relay Control is selected, the timer
speed settings are invoked when inputs 1-3 (INP1-INP3) are selected according to the table in section 5.4.
Page 20 of 76
Screen
Locked
Th 1:27PM
or > skip
1:27p
rpm
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
HCP3000 SERIES Variable Speed Pump
Buttons
Used Comments
< >
Press & hold < and > buttons for several seconds to
unlock Configuration Menu
< >
Use > to enter Configuration Menu
+ -
Use + to change clock setting
< >
Use > if clock is correct
+ -
Adjust day/time setting
< >
Move to next selection, then to next menu item
+ -
Select whether to display speed in rpm (Revolutions
per Minute) or % of full speed
< >
Move to next menu item
+ -
Set maximum running speed of pump
< >
Move to next menu item
+ -
Set minimum running speed of pump
< >
Move to next menu item
+ -
Select pump prime duration
< >
Move to next menu item
+ -
Select Standalone/Hayward or Relay Control
< >
Move to next menu item
+ -
Select Comm Bus Address for pump
< >
Move to next menu item
ISHCP3000VSPC Rev -B