Stop/Resume; Quick Clean; Remote Stop - Hayward HCP3000 Série Guide D'utilisation

6.10 Stop/Resume

1.
Pump is stopped;
press STOP/RESUME
2.
again to resume
normal operation.
Note: When Stop/Resume is pressed at any time during normal operation, the above message will be displayed.
The pump will stop within several seconds, and will remain stopped until Stop/Resume is pressed a second time, at
which point the pump will resume normal operation.

6.11 Quick Clean

1.
Quick Clean
Quick Clean running
2.
Quick Clean
3450 rpm for 60 min;
3.
Quick Clean
press resume to end.
Note: The above message will be displayed while Quick Clean is running. Quick Clean mode runs at the MAX allowed
speed and expires after 60 min, and it may be cancelled early by pressing the Stop/Resume button, at which time
the pump would return to normal operation.

6.12 Remote Stop

1.
Remote Stop
is engaged
Note: The above message will be displayed when an installed remote stop switch is activated. The pump will
remain stopped until the remote stop switch is deactivated.
Page 24 of 76
Screen
Screen
Screen
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
HCP3000 SERIES Variable Speed Pump ISHCP3000VSPC Rev -B