Wiring Diagrams; Input Power/Motor Wiring (Required); Wall Mounted Digital Control Interface Wiring (Optional) - Hayward HCP3000 Série Guide D'utilisation

5. Wiring Diagrams

5.1 Input Power/Motor Wiring (Required)

5.2 Wall Mounted Digital Control Interface Wiring (Optional)

Connection wire must be rated for a minimum of 300V, and may be up to 500 feet in length. Use removable
6-position terminal block connectors for wiring connection to display and motor drive board taking care to note the
wire colors and corresponding numbers next to the connectors. Do not connect to the upper input terminals shown
as light gray above.
Page 14 of 76
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
HCP3000 SERIES Variable Speed Pump
Figure 5.1-1
Figure 5.2-1
ISHCP3000VSPC Rev -B