User 1 Menu - ZANTIA ITACA Manuel D'utilisation Et D'entretien

Instructions for use
Encoder error: combustion fan
speed adjustment failure
Low water pressure
High water pressure
Incorrect date/time values
after prolonged absence of
mains power supply
Ignition failure
Voltage gap
Air flow regulation failed
No fuel
Brazier cleaning motor error
Flow switch sensor broken
Minimum air flow not reached
during check-up/'poor
draught' test failure during
check-up
Maximum air flow exceeded
Door error
Auger encoder error:
no encoder signal
Auger encoder error: failed
auger speed adjustment
I/O i2c modules error
'Excessive draught' test failure
during check-up
Service error. Indicates that
the programmed operating
hours have been reached.
You are required to call the
Assistance Service.
Messages
Description
Probe control fault during check-up phase
Water temperature inside the boiler above 99°C
Indicates that the programmed operating hours
have been reached.
Message that appears if the system is switched
off in a non-manual manner during the Switch-
on phase (after pre-loading): the system will only
switch off once operation is steady.
Periodic cleaning in progress
The message is displayed when DHW is reque-
sted (closed flow switch contact) since a flow
switch is used.
Display of operating statuses
Status
Off status
Check Up status
Ignition - preheating phase
Mod. ITACA-TROIA rev 01
Block status Er08
Block status Er09
Block status Er10
Block status Er11
Block status Er12
Block status Er15
Block status Er17
Block status Er18
Block status Er25
Block status Er39
Block status Er41
Block status Er42
Block status Er44
Block status Er47
Block status Er48
Block status Er52
Block status Er57
Block status Seru
Code
Sond
Hi
Clr
Off del
Pclr
Flu
Code
-
Chec
On 1
translated from the original text
Ignition - pre-loading phase
Ignition - fixed phase
Ignition - variable phase
Stabilisation status
Normal status
Modulation status
Standby
Safety
Switch-Off status
Block status
Restart status
4.2

USER 1 MENU

Displays • Tp: puffer temperature [°c]
• Ta: basic room temperature [°c]
• Tf: smoke temperature [°c]
• Uf: combustion fan speed/volta-
ge [rpm/volt]
• Co: auger ON time [rpm/sec]
• Pa: water pressure [mbar]
• Fc: firmware code and revision:
fysyi01000034.X.Y
• 510: Manufacturer's product
code: 0y.0X
Operating po- Simply click k2 or k6: the d2
wer adjustment display flashes. It is possible to
change the power from the values
available by clicking several ti-
mes. E.g.: 1–2–3–4–5–A
(A= automatic combustion)
After 3 seconds, the value is saved
and the display goes back to
normal.
Pellet manual The bottom display shows load,
loading whereas the top one shows the
loading time elapsed. To stop lo-
ading, press any button. Loading
is Automatically stopped after
300 seconds. This function is only
available in an Off status
Pellet feeding Enables you to change the default
correction settings of the speed or ON times
of the Auger. The set values are
between –7÷7. The default setting
is 0.
Combustion Enables you to change the default
fan correction settings of the Combustion fan
speed. The set values are between
–7÷7. The default setting is 0.
On 2
On 3
On 4
On 5
-
Mod
Stby
Saf
Off
Alt
Rec
EN
39