EdilKamin BERING PLUS Installation, Usage Et Maintenance page 28

THERMO TECHNICAL CHARACTERISTICS according to EN 303-5
Heat input (burnt)
Nominal thermal power
Water yield
Emissions CO 13% O2
Fume temperature
Fuel consumption
Minimum draught
Hopper capacity
Water content
Maximum operating pressure of the water
Maximum operating temperature of the water
Autonomy
Heatable volume *
Smoke outlet pipe diameter (male)
Air intake pipe diameter (male)
Weight including packaging
TECHNICAL DATA FOR THE DIMENSIONING OF THE FLUE
Nominal thermal power
Temperature of fumes on exit from the discharge pipe
Minimum draught
Fume fl ow capacity
* The heatable room dimensions are calculated on the basis of home insulation in compliance with Italian law 10/91, and subse-
quent changes together with an expected heat output of 33 Kcal/m³ per hour.
CARATTERISTICHE ELETTRICHE
Power supply
On/off switch
Average power consumption
Power consumption during ignition
Protection on mains power supply* (see page 26)
Protection on electronic circuit board
N.B.
1) keep in mind that external devices can cause interference to the operation of the circuit board.
2) warning: activity on live components, maintenance and/or checks must be carried out by qualifi ed personnel.
(before carrying out any maintenance, disconnect the appliance from the mains electricity)
The above data are indicative and are those resulting during certifi cation on the part of the notifi ed body.
EDILKAMIN s.p.a. reserves the right to change the products at its discretion without notice.
CHARACTERISTICS
- 28
-
Nominal power
13,3
12
90,1
0,005
72
2,8
60
12
35
1,5
90
20
315
80
40
300
Nominal power
12
85
5
8,7
230Vac +/- 10% 50 Hz
si
150 W
400 W
T2A, 250 Vac, 5x20 Fuse
T2A, 250 Vac, 5x20 Fuse
Reduced power
4,1 kW
3,7 kW
90,2 %
0,028 %
43 °C
0,9 kg/h
kg
10 Pa
Litres
bar
°C
63 hours
3
m
mm
mm
kg
Reduced power
3,7 kW
50 °C
Pa
3 g/s