Burg Wächter secuENTRY easy plus 5652 Mode D'emploi page 46

secuENTRY easy plus keypad assembly
The keypad is only included in the secuENTRY easy Pincode and
secuENTRY easy Fingerprint set.
Attention! Please note that the keypad should not be attached
to the door itself so that no vibrations are transmitted when the
door is shut. The membrane affixed to the back of the keypad
should not be sealed with glue and/or any other substance under
any circumstances! Exchange of air must also be possible after
the installation!
• Determine the installation position for the keypad.
For this purpose, enter the opening code (e.g. PIN code, fingerprint...)
at the desired mounting location and check whether the lock opens.
• Place the keypad accordingly.
If you decide on gluing the wall holder, please be sure to provide clean
surfaces free from e.g. grease, oil and silicon films or any other impurities.
Completely remove the protective film from the adhesive pads included,
attach all the pads on the wall holder and then press firmly onto the desired
position. When mounting in colder temperatures, please note that the
full adhesive strength is achieved only after 72 hours at 20°C. Heat will
accelerate the process (e.g. at 65°C; full adhesive strength is achieved in
one hour).
When gluing the holder plate on the colour sight protection film, the above
described conditions relating to cleanliness of surfaces and firmness of the
adhesive pad should be observed.
To facilitate a bubble-free application of the colour privacy film, please
proceed as follows:
• Pour some water with a couple of drops of dishwashing detergent into
a glass, stir it carefully free of foam, and then use it to gently moisten
the surface on which the film is to be applied.
• Pull off 1 cm of film at an edge of the white protective sheet and straighten
it out. To change the position, lift the film carefully and attach it again.
• Then wipe the adhesive film, e.g. with a plastic spatula, from the contact
surface outward in the direction of the protective sheet that is still attached.
Attention! Do not use more liquid than absolutely necessary.
• Slide the keypad in from above until the locking latch of the base plate
engages into the keypad housing. In this way, the keypad is protected
against undesired removal.
50 | English secuENTRY easy