Firmware Update - Burg Wächter secuENTRY easy plus 5652 Mode D'emploi

Transmission power
The system or power consumption is optimised via the transmission power,
and the wireless range of the cylinder and the keypad are increased or
reduced. As delivered, a low transmission power is set in order to obtain
the longest possible battery life. The transmission power should only be
increased if repeated transmission problems should occur. The setting
normally does not have to be adjusted.

Firmware update

The secuENTRY keypad can be sequentially updated via the Burg-Wächter
ConfigApp. Please refer to the instructions for the ConfigApp for the
exact procedure.
Display contrast
• Switch on the keypad using the key
• Then press FUNC – "Menu/Code Change" appears
• Scroll using the 2 key until the Administrator menu appears
• Confirm your selection using
• Scroll with the 2 key until "Setup" appears
• Confirm your selection using
• Scroll with the 2 key until "Display contrast" appears
• Confirm your selection using
• Select the desire contrast level using the 1 key (weaker) or
the 2 key (stronger)
Programming
You can input into the keypad a data set created with the PC software via
Programming. The data set can be programmed using the PC software as
well as the secuENTRY ConfigApp.
• Switch on the keypad using the key
• Then press FUNC - "Menu/Code change" appears.
• Scroll using the 2 key until the Administrator menu appears
• Confirm your selection using
• Scroll with the 2 key until "Set-up" appears
• Confirm your selection using
• Scroll with the 2 key until "Programming" appears
• Confirm your selection using
• Enter the administrator code in order to acquire the authorisation
for programming
• The message "Start the file transmission" appears in the display.
The keypad is now in programming mode and can be programmed using
the PC software or the ConfigApp.
secuENTRY easy
.
.
English | 43