Technical Details - Burg Wächter secuENTRY easy plus 5652 Mode D'emploi

Technical details

Blocking times
Display
Reliable ambient
conditions*
Protection class
Voltage supply
Transmission power
to
and frequency
range:
at
Opening
Depending on the equipment variant, the secuENTRY easy plus set can be
operated via a 6-digit numerical code, the BURG-WÄCHTER KeyApp, with
the passive transponder, with the active transponder or fingerprint.
Opening with PIN code
• Switch on the keypad using the key
• Enter the 6-digit PIN code (factory setting "1-2-3-4-5-6").
"Please turn the rotary knob" appears in the display, and the LED
integrated in the cylinder flashes once when the opening is successful.
• Turn the cylinder knob
Opening with Fingerprint
• Switch on the keypad using the key
• Move the programmed finger from the top to bottom centrally over the
sensor. "Please turn the rotary knob" appears in the display, and the LED
integrated in the cylinder flashes once when the opening is successful.
• Turn the cylinder knob
Opening with Passive transponder
• Hold the transponder at the front at a maximum distance of 1 cm from
the cylinder knob. The LED which is integrated in the cylinder flashes once
upon successful opening.
• Turn the cylinder knob
Please note that during the opening process with the KeyApp, the
active or passive transponder, the keypad must not be switched on
via the
secuENTRY easy
After 3 x wrong
code is entered 1 minute,
then always 3 minutes
Can be set in 12 languages
-15 °C / +50 °C / up to 95 % rel. humidity
(non-condensing) The display can react slowly or
darken under extreme temperature changes.
Keypad protection class PINCODE IP65
Keypad protection class Fingerprint IP55
Cylinder protection class IP65
2 x MIGNON LR6 AA ALKALINE for the keypad
2 x MIGNON LR6 AA ALKALINE for the inner knob
1 x CR 123A Lithium for the outer knob
Bluetooth Low Energy, Maximum Transmit
Output Power 7,5dBm
Frequency usage range 2.402GHz ... 2.483 GHz
key beforehand!
English | 33